Additional Images

Reid 44 / 10 Bolt Crossover Knuckle

C10002R
Pricing: $310.99

Qty:

Description

Reid Racing Dana 44 / 10 bolt right hand flat-top knuckle. This is a popular selling knuckle that is cast thicker and stronger than the factory knuckles. It is "Made in the USA" by Reid Racing. If you want to upgrade to cross-over or high-steer on most Dana 44 or Chevy 10 bolt front axles, this is what you need! This is a factory replacement, right side, flat-top knuckle that is milled, drilled, and tapped to 9/16x18 on the flat-top. This knuckle can be used for cross-over steering on '77 to '91 Chevy front axles or full high-steer on '71-'91 Chevy front axles. If you are using this knuckle for cross-over steering and plan to hook your factory tie-rod, please note that the taper direction through the factory cast-in steering arm is "bottom up". All Chevy front axles from 1977 to 1991 were tapered from the bottom up and did not have a flat-top knuckle on the passenger side. As mentioned above, if you are going to run high-steer it will not matter because you will not use the factory arm location.

Note: 1971 to 1976, all Chevy Dana 44 front axles had "top down" taper, as well as all Jeep Wagoneer front axles.

Remember, this knuckle has 6 spindle studs and will not fit Dodge, Ford, or Scout 44 front axles. Be sure the axle you are installing this knuckle on uses 6 bolt spindles!


Details

  • C10002R
  • C10002R
  • Reid
  • New

Categories

Shipping Information

  • Item Requires Shipping
  • 14.0 lbs.

Customer Reviews

Comment Total Reviews (0)

Write the First Review!

You must login to post a review.