WFO Concepts | Off Road Parts and Fabrication

Featured Categories

JEEP JK EXTREME TIE ROD, 2" DOM

The bar is made out of 2" x .250 wall DOM. We weld in 1.25 tube inserts and run the large Fab Series Offset Forged tie rod ends with replaceable cartridges. The Fab Series tie rod ends are much larger than any other aftermarket tie rod end. One of the nice features of the Fab Series ends is if the cartridge ever wears out, you can swap in a new cartridge without needing to get your vehicle realigned. Plus, one cartridge will fit either side.

JEEP JL/JT EXTREME TIE ROD, 2" DOM

Our Extreme Duty JL/JT Tie Rod will be the last tie rod you ever have to buy for your Jeep JL/JT!

JL/JT HD DRAGLINK KIT

This is our JL/JT heavy duty draglink. The draglink welded together using our high quality hex shaped tube inserts, and 1.75"x.120" wall DOM tubing. It comes with heavy duty rebuildable, cartridge style, forged draglink ends, that are huge! The threads on the draglink ends are a massive 1.25"x12. When it comes time to rebuild your HD draglink, simply buy new cartridges from us.

TOYOTA TACOMA & 4 RUNNER CROSSMEMBER, '95.5-'04

This is our Toyota Tacoma/4 Runner 3 Piece Crossmember. This is an easy solution for those looking to Straight Axle their '95.5-'04 Toyota Tacoma or 4 Runner. We usually run a Radius Arm setup on all of our builds, but you could use this as a good base for a 3 link set up by mounting your lower links to the crossmember then add one upper 3rd link and mount it under the frame or, you could even create a triangulated 4 link.

WFO TOYOTA TACOMA '95.5-04 BUILDERS SAS KIT - USING D44

This is our Builders kit for the 1995-2004 Toyota Tacoma using a 1974-1977 D44 1/2 Ton Axle.

WFO TOYOTA TACOMA '95.5-04 SAS KIT - USING '05+ FORD SUPER DUTY AXLE

This is our Solid Axle Kit for a 1995.5-2004 Toyota Tacoma using a '05+ Ford Super Duty Axle.

WFO GM HD 6" SAS KIT USING FORD SUPERDUTY AXLE (RADIUS ARM)

This is our 6" lift, Radius Arm, Solid Axle Kit for 2011 to 2018 GM 2500 and 3500 single wheel trucks. It is designed to use a Dana 60 front axle from a 2005 and newer Ford F-250 or F-350 4x4.

Dodge Long Arm Builders Kit

These are our WFO 2nd and 3rd Gen Dodge long arm kits. These are builders kits so you have some versatility with them. The lower links are slightly long so you can choose where to mount them on your frame. There is cutting and welding involved.

DODGE DANA 60 FRONT U-BOLT KIT

This kit includes: two 3.125” x 8” x 5/8” u-bolts; one 4" x 10" x 5/8" u-bolt; two 5" tall Grade B-10 9/16" coarse All-thread studs; eight high nuts; eight hardened washers; one passenger side spring plate; and one drivers side spring plate.