GM HD 2000-2010 3" SAS Kit Pitman Arm

This is the pitman arm we use in our 2000-2010 GM HD 3" Straight Axle Swap Kit.

We take a no hole, flat pitman arm and drill a draglink taper hole from the bottom up at 6.25" out. Then, for clearance purposes, we cut off the excess of the pitman arm and round the end to make it look smooth and complete.

PLEASE NOTE:  If you are replacing the pitman arm in one of our kits manufactured between 9-20-22 and 6-12-24, please call us at 530-268-9494 to discuss options.  These kits used the same pitman arm BUT it was drilled bottom up with a tie rod taper.