close search

D60 Kingpin Crossover Arm Kit

Arm Only or Arm with Hardware
Your Name:

Email address:


Dana 60 Kingpin, crossover steering arm kit.  This is one of our most popular steering arm kits.  The arm will allow you to change your kingpin Dana 60 front axle to crossover steering. 

The arm is CNC machined from mild steel then Zinc plated to help fight off corrosion.  It has 5 holes in case you are using it with a Reid Racing 5 bolt knuckle.  The end of the arm is milled and tapered at a 10 degree angle in order to make up for kingpin inclination.  The hole in the arm is 6.25" from the center of the kingpin.  The taper fits standard Chevy double pivot draglink ends, part number ES2026R or ES2027L.  Remember, Chevy tie-rod ends will NOT fit in this arm.  Tie-rod ends have a smaller taper than draglink ends!  The arm slips right over most stock kingpin caps, and requires the use of studs and tapered nuts.  If you are using factory studs and nuts, you will need to drill the arm out to 17/32".

If you purchase the kit, you will get the steering arm, 4 ARP studs and tapered nuts, and a new kinpin cap and gasket.


WARNING: This steering arm is built to be installed using studs and tapered nuts, NOT bolts!


D60 Upper Kingpin Cap RH Only

D60 Upper Kingpin Cap RH Only

Price: $14.99
Add To Cart
Drag Link and Tie Rod Kit

Drag Link and Tie Rod Kit

Price: $535.95
Add To Cart
Item added to your shopping cart.
Item added to your wishlist.