WFO Toyota Tacoma 95.5-04 BUILDERS SAS Kit - using D44

This is our Builders Solid Axle Kit for a 1995-2004 Toyota Tacoma using a 1974-1977 Ford D44 1/2 ton front axle.

This kit is for the front end only and requires welding. This is a radius arm kit and will get you approximately 5.5" of lift and is designed to be used with a 10" travel coil-over shock (sold separately)

The kit is designed to run the front factory driveshaft with our supplied flange for the axle.

The Lower Links are made out of 2" x .250 DOM and the upper links are made out of 1.5" x .250 DOM.

MADE IN THE USA!

* * This kit ships via flat rate truck freight.

* * In store pickup available - call to order.

Kit includes:

• 3 piece, weld on crossmember (raw metal)
• Frame Plates
• Pair of Coil over shock towers
• Drop pitman arm
• Axle Brackets for Links
• DOM for Lower and upper Links
• Metal Cloak Duroflex Joint and 1.5" bushings for lower links
• 1.5" bushings and heim joint for upper links
• Upper and Lower Trackbar brackets
• DOM for Draglink, Trackbar and TieRod
• Moog Draglink and Tie Rod Ends
• D44 Steering arm for Passenger Side plus Studs, Nuts and Cone Kit
• 26 spline flange for front driveshaft

Welding required.