D60 Steering Arms, Standard Kingpin with 4 ARP Studs

Dana 60 High Steer Arms, Standard Kingpin w/4 ARP Studs

Dana 60 Kingpin Standard High-Steer Arm Set.  This high-steer arm set is designed to fit kingpin Dana 60 front axles.  The arms slip right over the top of the existing kingpin caps.  Each arm has one tapered hole that will accept a Chevy tapered tie-rod end.  The tapered hole is 6.25" from the center of the kingpin.  These arms are designed to use the "inverted T"  style steering setup. 

Suggested tie-rod ends for "Inverted T":  1 x ES2233LM, 2 x EX2234R, 1 x ES2027L.

If you are installing these arms on Chevy or Dodge kingpin axles, you may re-use the factory studs on the drivers side.  In that case, you will only need to purchase the WFO 1110-1K.  In this kit, we drill the stud holes in the driver's steering arm slightly larger to 17/32" in order to fit the larger shoulder of the factory studs.  On the same Dodge and Chevy axles, you will also need one more sheetmetal kingpin cap for the drivers side.  This is because the cap is built into the factory steering arm that you will be removing. 

This Kit includes:
WFO 1111: D60 High Steer Arm, LH (Qty: 1)
WFO 1112: D60 High Steer Arm, RH (Qty: 1)
DAN37307: D60 Kingpin Cap Gasket (Qty: 2)
WFO 1152: D60 High Steer Nuts (Qty: 4)
WFO 1153: D60 High Steer Studs (Qty: 4)