D44 to Toyota, 1985 and up, 2 bolt pattern

Toyota Driveline Flange, Dual Pattern, 26 Spline. 

If you are putting Dana 44 axles in your mid 80's Toyota, this flange will allow you to use your factory Toyota driveline. This flange has the common Toyota driveline patterns, but the spline count and seal size to fit standard Dana 44 and Dana 30 axles.

The two patterns are:

• 60mm x 60mm (square) with 10mm Holes for '84 and up Toyotas
• 64mm x 56mm (rectangle) with 8mm Holes for '78-'83 Gen 1 Toyotas

The OD is 4.375" and Pilot is Female, 1.810"

NOTE: If you have a different pattern then these two patterns above, there is room for you to drill additional holes.

MADE IN THE USA!