close search

WFO Dana 60 High Steer Arms, Standard Kingpin

RESET
Arms Only Or With Studs
 
Qty:

Email address:

Message:

Dana 60 Kingpin Standard High-Steer Arm Set.  This high-steer arm set is designed to fit kingpin Dana 60 front axles.  The arms slip right over the top of the existing kinpin caps.  Each arm has one tapered hole that will accept a Chevy tapered tie-rod end.  The tapered hole is 6.25" from the center of the kingpin.  These arms are designed to use the "inverted T"  style steering setup. 

Suggested tie-rod ends for "Inverted T":  1 x ES2233LM, 2 x EX2234R, 1 x ES2027L.

If you are installing these arms on Chevy or Dodge kingpin axles, you may re-use the factory studs on the drivers side.  In that case, you will only need to purchase the WFO 1110-1K.  In this kit, we drill the stud holes in the driver's steering arm slightly larger to 17/32" in order to fit the larger shoulder of the factory studs.  On the same Dodge and Chevy axles, you will also need one more sheetmetal kingpin cap for the drivers side.  This is because the cap is built into the factory steering arm that you will be removing. 

RELATED PRODUCTS

Full High Steer Inverted T Kit

Full High Steer Inverted T Kit

WFO IT-15-KIT
Price: $289.99
Add To Cart
Item added to your shopping cart.
Item added to your wishlist.