This is our Toyota Tacoma/4 Runner 3 Piece Crossmember. This is an easy solution for those looking to Straight Axle their '95-'04 Toyota Tacoma or 4 Runner. We usually run a Radius Arm setup on all of our builds, but you could use this as a good base for a 3 link set up by mounting your lower links to the crossmember then add one upper 3rd link and mount it under the frame or, you could even create a triangulated 4 link.
This crossmember is the new mounting point for your lower links and your Transmission / Transfer Case. The center section conveniently removes so you can easily service your Transmission without removing links.
On a 4 Runner, you'll need to cut off our locating tabs on the frame mounts so they sit flush on the frame.
The crossmember includes:
- Driver, Passenger and Center Section
- Grade 8 hardware to bolt three pieces together
The crossmember ships Raw Metal so you will need to paint it after you weld it on the frame!
NOTE: Has NOT been tested with dual cases. We will be working on this so check back.
Click here for Instructions: