close search

10 Bolt/ D44 Cross-Over Steering Kit, Fullsize, Bent Draglink

RESET
With or Without Ball Joints
 
Qty:
Your Name:

Email address:

Message:

10 Bolt Chevy / Dana 44 cross-over steering kit.  From 1977 to 1987 all full width Chevy/GMC 10 bolt and Dana 44 front axles did not come with a passenger side "flat top" knuckle.  In order to install cross-over steering, you need a "flat top" knuckle.  This kit comes with everything you will need to install cross-over steering with one of the above axles.  This kit fits 1/2 ton and 3/4 ton front axles.  This comes with a bent draglink tube to clear the stock Chevy cross-member in '73-'87 Chevy and GMC's.  The draglink is also extra long in order to fit 4" to 10" lifted trucks.  You will need to cut the draglink to your desired length and weld the hex shaped tube inserts into the 1.5"x.219 wall DOM tubing.

Kit includes:  1 new flat top knuckle that is milled/drilled/and tapped.  (The knuckle is tapered from the bottom up in order for the stock Chevy tie-rod to be re-installed),  WFO 1104M pitman arm, MOOG ES2026R and ES2027L draglink ends, pair of tube inserts, 1.5" cross-over steering arm that is 7" long (with steering arm studs/nuts/cones), Bent draglink tube from 1.5"x.219 wall DOM tubing.

This kit comes either with or without MOOG ball joints and spindle studs/nuts installed.

WARNING: Be sure to specify if you want top down or bottom up taper on your knuckle. All Chevy 10 bolts and 44's were bottom up from '77 to '87.
Item added to your shopping cart.
Item added to your wishlist.